Technical > Ignition

Ignition outputs and lack of sparks

(1/2) > >>

se7ensport:
Looks like I got ahead of myself asking about maps  :-[ 

I can get sparks using the originally configured as 3 (EC36 Pin 36) and 2 (EC36 Pin 34), but I'd already built the loom and planned to use pins 33 & 35 as per Phat bobs user guide, however I've tried selecting them within ignition outputs and all I get is continuous earth- possibly selected for something else????

is there a simple way round this or just get the stanley out and cut off the sheathing and start again?


Cheers

Alex

[email protected]:
As discussed on the phone, the UserGuide pictures were wrong, as the FET layout on the board was changed to provide better cooling potential. The new pins are described here:

I'll be updating the UserGuide this evening.

se7ensport:
cheers Rob, all sorted

[email protected]:
Its sparking or you've got it running?

se7ensport:
Sparking, you'll know when its running  ;D

I'd spent most of the weekend tinkering, so to keep the mrs happy decided to call it a night while things were going well, if I leave the car with an issue to be resolved I'll spend the rest of the night trying to figure it out, reading or on the net popping in and out to the garage etc....

I did manage to start converting the maps i have while watching a film with her  ;)

Navigation

[0] Message Index

[#] Next page