mitsubishi lancer 4-8 4G63T engine

[Kamuto]

hello, is there any way to run this mitsubishi 4G63T engine using stock crankshaft and cam hall sensors with vems? thanks
pics of triggers:
cam side
http://www.evomoto.com/article_images/steps/step_492.jpeg
http://www.evomoto.com/article_images/steps/step_512.jpeg
http://www.evomoto.com/article_images/steps/step_513.jpeg
http://www.evomoto.com/article_images/steps/step_516.jpeg

crankshaft side
http://www.jayracing.com/images/products/Kiggly%20Crank%20Trigger%20OEM.JPG
http://www.vems.hu/files/Fero/mitsubishiEVO/crank1.jpg
http://www.vems.hu/files/Fero/mitsubishiEVO/crank2.jpg

[Kamuto]

how it must look in vems style?
Ignition Settings:

Trigger Angle: 69 - 76 should be really close-- you'll need to dial this in properly to get your based timing correct as mentioned above
Trigger Angle Addition: 0
Cranking Timing: Time Based
Cranking Advance Angle: 15
Hold Ignition: 0
Spark Output Inverted:  (NO if using stock ignitors)   (YES if using BIP373s) 
Fixed Angle: -10  (set this one to X degrees when calibrating the timing)
Trim Angle: 0

Trigger wheel settings:
Wheel decoder base teeth: 2
2nd trigger enable: 2nd trigger
2nd trigger active edge: rising
2nd trigger and missing teeth: None missing
Trig pos A: 2
Trig pos B: 1
Dual dizzy mode: normal
Wheel decoder: 025 style

http://www.diyautotune.com/tech_articles/how_to_megasquirt_your_4g63_powered_dsm_eclipse_talon_laser.htm

anyone?