« previous next »
Pages: [1]

Author Topic: Fuel film question.  (Read 4527 times)

Offline JohnP

  • Jr. Member
  • **
  • Posts: 33
  • BHP: 0
Fuel film question.
« on: January 01, 2014, 06:08:39 pm »
Looking to remove some fueling when the throttle is lifted. Is the en lean down scale where the adjustment is made for temporary leaning?

Thank you. John
Logged

Offline VEMS

  • Administrator
  • Sr. Member
  • *****
  • Posts: 487
  • BHP: 22
Re: Fuel film question.
« Reply #1 on: January 04, 2014, 02:43:45 pm »
Hello John,

The function you are looking for is either overrun fuelcut (tps based) or low map fuelcut (map based) both can be enabled at the same time. These can be found in base setup -> revlimit / overrun /safety menu -> overrun fuelcut section.

Best regards, Dave
Logged

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Fuel film question.
« Reply #2 on: January 05, 2014, 05:33:29 pm »
I think he means enleanment, we can change the accel enrich into a positive and negative scaling so that it does both enrichment and enleanment which I would be interested in having.
Logged

Offline VEMS

  • Administrator
  • Sr. Member
  • *****
  • Posts: 487
  • BHP: 22
Re: Fuel film question.
« Reply #3 on: January 06, 2014, 05:52:14 pm »
Hello Gunnar,

I have seen your proposal for decel enleanment in: http://www.vems.hu/wiki/index.php?page=MembersPage/GunnarReynisson/FirmwareRequest, this makes sense; We have some more accel enrichment changes coming up  (after the big firmware overhaul in 1.2.20 (now released for testing) ),  it might be possible to integrate this proposal as well.

Best regards, Dave

Logged
Pages: [1]
« previous next »