VEMS Community Forum
VEMS => Modifications and Repairs => Topic started by: vsc on August 17, 2017, 10:05:45 pm
-
device stays in boot mode and I can not upload firmware or anything? any sugestions?
-
Board is new, car was running couple hours then desided to change fw from 1.2.31 to 1.2.38 car started idled for minute or two and then stalled tried to start couple times and then the boot mode poped out and no serial number
-
Board is new, car was running couple hours then desided to change fw from 1.2.31 to 1.2.38 car started idled for minute or two and then stalled tried to start couple times and then the boot mode poped out and no serial number
seems your wiring is bit fucked up :) you can always ask for a new bootloader and then reinstall fw. but usually that happens from bad wiring or something
-
Wiring is ok conected other vems car now runing.How is it done? The request for new bootloader?
-
Wiring is ok conected other vems car now runing.How is it done? The request for new bootloader?
best would be to fill wiki page for that, explaining situation, will get instructions there.