VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: Brk97 on June 28, 2018, 11:21:46 am

Title: VEMS ETC Setup
Post by: Brk97 on June 28, 2018, 11:21:46 am

I've ordered an ETC Bridge Driver from the VEMS Online shop yesterday. (Order #14529) How can i install the ETC module onto the VEMS ECU ? I'd like to install the PWM pin to the OC0 pin, i already know that. But i don't know where to install the ETC DC motor pins.

Thank You in advance...

Title: Re: VEMS ETC Setup
Post by: Brk97 on June 28, 2018, 11:26:52 am

(https://image.ibb.co/ny7MVT/Scan.jpg)

Title: Re: VEMS ETC Setup
Post by: jrussell on July 27, 2018, 03:26:29 am

Only OC0 and gnd are needed from the ecu on the 6 pin connector. The etc motor is connected to the 10 pin.