VEMS Community Forum

Technical => Wideband & EGT Gauge => Topic started by: iwbs on August 10, 2016, 08:07:18 am

Title: setting up display-only round
Post by: iwbs on August 10, 2016, 08:07:18 am

Hi, I'm trying to set up my display-only round following this guide: http://www.vems.hu/manual/vemstune/help2/htmls/main/aim.html#conf_methods I tried offline method with one serial cable but I got stuck where it says to connect v3 to vemstune, I can't seem to find display menu/round main display dialog/AIM port button anywhere in vemstune v3 menu. firmware 1.2.31, round firmware 1.5.8. Could anyone please help me?

Title: Re: setting up display-only round
Post by: PeepPaadam on August 10, 2016, 05:46:58 pm

You need inverted pinout for it, that is usually the problem.

Title: Re: setting up display-only round
Post by: iwbs on August 10, 2016, 06:16:57 pm

If you mean that short wire which inverts pinouts, then I have it. Bought the round from you and also got this short inverter wire. Uploaded the firmware to round and set up slots for display, but I just can't find this AIM port button to set the proper com port.

Title: Re: setting up display-only round
Post by: iwbs on August 10, 2016, 07:35:45 pm

Looks like I got it all sorted out now, Uploaded firmware 0.5.8 which is AIM compatible unlike 1.5.8