VEMS Community Forum

Technical => Triggering => Topic started by: Kahvel on July 30, 2013, 07:55:13 pm

Title: 3 wire VR sensor for crank?
Post by: Kahvel on July 30, 2013, 07:55:13 pm

Hey!
I'm setting up my VEMS wiring and I have few issues.I want to use original VR sensor but it has 3 wires.
Looks like that.Car is VW R32 3.2 engine.Sensor is BOSCH.
(http://www.driven2automotive.com/ebaystore/images/F0281002138.jpg)

Title: Re: 3 wire VR sensor for crank?
Post by: lost on July 31, 2013, 10:13:39 am

One of the wires (pin) is cable shielding and its not connected to anything, just wrapped around other two cables. You can use this sensor for vems...