VEMS Community Forum

VEMS => Configuration => Topic started by: Matus on July 31, 2017, 08:11:59 pm

Title: AIM between Vems and Mechatromotive RCD
Post by: Matus on July 31, 2017, 08:11:59 pm
Hi,

I am using Mechatromotive display which is able to read data from VEMS. I was using that during previous year without issue however.

Currently strange behavior appear (by new vems&vemstune version I suppose). There is interference in CLT value it blicking between real value and some strange value that is altering based on engine RPM .. ( like 1/10 of engine rev)

You can check recorded video 1  https://youtu.be/U45RC8kHSlk (https://youtu.be/U45RC8kHSlk)

&

video 2 https://youtu.be/mBD1Y5wtCvc (https://youtu.be/mBD1Y5wtCvc)

Unfortunately I don't have video where it was working well. Now the question is what can I do ?

Also we are running higher oil pressure where upper limit is 6Bar which means that I would like to use also also pressure sensor than PX2..100PS ..
( currently have SSI  P51 150PSI 0.5 - 4.5V )  would it be possible to create "custom sensor " for AIM ?   

 
Title: Re: AIM between Vems and Mechatromotive RCD
Post by: Matus on September 11, 2017, 08:23:37 pm
Strange value reading has been fixed by firmware upgrade that I got from Mechatromotive.

However still have issue that AIM values are not correct for things like Oil Temp. Pressure .. etc.

I am reading values from analog and would like to forward values to display .. to see it.

Any suggestion ?
Title: Re: AIM between Vems and Mechatromotive RCD
Post by: Kamuto on September 11, 2017, 08:32:55 pm
Quote from: Matus on September 11, 2017, 08:23:37 pm
Strange value reading has been fixed by firmware upgrade that I got from Mechatromotive.

However still have issue that AIM values are not correct for things like Oil Temp. Pressure .. etc.

I am reading values from analog and would like to forward values to display .. to see it.

Any suggestion ?
aim is working fine... check your settings i believe :))
Title: Re: AIM between Vems and Mechatromotive RCD
Post by: utkuselamoglu on September 25, 2017, 09:32:01 pm
Quote from: Matus on September 11, 2017, 08:23:37 pm
Strange value reading has been fixed by firmware upgrade that I got from Mechatromotive.

However still have issue that AIM values are not correct for things like Oil Temp. Pressure .. etc.

I am reading values from analog and would like to forward values to display .. to see it.

Any suggestion ?

aim has problems with oil press and oil temp on analog channels. try it over ECM