VEMS Community Forum

Technical => Solenoids => Topic started by: 306 2.0 16v on October 04, 2012, 02:30:10 pm

Title: Setup stepper
Post by: 306 2.0 16v on October 04, 2012, 02:30:10 pm

Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.

regards dennis

Title: Re: Setup stepper
Post by: Kamuto on October 05, 2012, 01:15:53 am

Quote from: 306 2.0 16v on October 04, 2012, 02:30:10 pm

Hello. I have put a vems on my peugeot 306 2.0 16v and keep many of the same settings that I had on my old peugeot 205 2.0 8v. but the new car running with a stepper instead of a acuacot. and I do not know how to get it to work. it is connected in the sense that the EC 18 is set to pin10 two A pin11 two B pin 5 to C pin 4 to D ..
but how should the control of mega tune I run with the old version 1.0.53
hope to have someone who can help me.

regards dennis

download vemstune + use newer firmware. http://vems.hu/download/v3gui/NIGHTLY/

Title: Re: Setup stepper
Post by: 306 2.0 16v on October 07, 2012, 06:40:57 pm

Thanks for your reply. It seems to idle works now.

so now all I need to get the engine to take rpm. it will only go up in rpm when it reaches 50% throttle.

thanks dennis

Title: Re: Setup stepper
Post by: gunni on October 08, 2012, 05:21:10 pm

It´s best to post a log and config.

you can even do that from within Vemstune, which you should be usinga and post the link to here.