Hi All.
In my hunt for making the subaru ready for my costumer in a hurry,
Can anyone give my info on a 4-1 cranktrigger will work with 1.1.81
This i the 6tooth trigger that is on the car now, i would if it works then grind 3 teeth of.
(http://img.photobucket.com/albums/v41/Denmark/44750940.jpg)
Do you think this will work , if i remove the tooth before 90degrees before tdc?
its running wastedspark
and does this then look right
(http://img.photobucket.com/albums/v41/Denmark/pritrigger.jpg)
(http://img.photobucket.com/albums/v41/Denmark/reftooth.jpg)
Thanks,
Skassa
It is not good idea. You remove the only tooths what can be used for precise advance calculations: around 60deg BTDC.
May better is to keep only these two tooth + one on the cam?
Best is to make 36-1 or 24-1.
okay thanks,
It was not possible for me to have some triggerwheels made today, so i´m going to have to try some more to get this working this weekend,
any suggestions for what to check that can make a 4500rpm limit, it could be that there is something missing on the board i have gotten from Vems, compared to what there usely is mounted, i just dont know what to look for ?.
Last night when i tried to change the cam sensor with another one, i could make the problem worse when making a bigger gap to the cam wheel, it would do the same just at 2000rpm, when the gap was around 4-5mm or so,
So some thing that can make the sensor closer without moving the sensor, as its not possible to fit closer to the wheel, maybe this could help
i´m open for all suggestions that i can figure out how to do :)
/Skassa