hello all,
Originally I had EC18 pin one wired to my first knock sensor, but when I installed dual lambda's I had to use pin 1 for this......
This leaves me with wiring in my knock sensors some other way...anyone help out here.....how or what do I have to do to get them working again, or will I now not be able to wire them back in?
Not sure which input I can use, as I have dual knock sensors, sensor two is wired to EC18 pin 3, and the grounds for both on EC18 pin 2, but I need an input for sensor 1, which is now a lambda input.
cheers for any help
scott
ok so I pulled the ecu out today to see how its wired.....
I've disconnect EC18 pin6, as I don't use it and re-wired it for my knock sensor....so this should do the trick....
Not that I am using any knock sensors at the moment, just want to be ready for when this does get implemented...
scott