VEMS Community Forum
General Category => General Discussion => Topic started by: S.g on June 05, 2015, 07:14:24 am
-
I ordered my V3 for dual knock and it is wired for it. In the base setup menu I have 'knock sampling' and 'knock control' but the 'knock channels' is there but not bold/not selectable. In the sampling I don't have the full menu as seen in the setup help guide. I don't have the 'knock realtime' or 'noise interval' or 'defaults'
When I set 'knock chan' from 240 to 0, I get an 'invalid' message in the 'Ecu logger' menu.
I don't have a knock table either
I'm hoping its a firmware issue rather than the other thought that I was given an ECU without the knock chip. Is there any way to check if I actually have the knock chip there???
The supplier won't respond to emails.
Thanks in advance
-
Just uploaded newest firmware and loads of new cool stuff, including all knock menus!!!
-
Hello S.g.,
I suspect you found the answer to your question already ? Knock help is available at: http://vems.hu/vt/help/v3/v3_knock_control.html (or from VT dialogs with pressing F1).
Best regards, Dave