Print Page - M50 NV pinout to Vems pinout

Title: M50 NV pinout to Vems pinout
Post by: maxout on September 22, 2015, 06:35:25 AM

Is there any good document that shows the pinouts from motronic connector to vems connector? Also how after cutting the orginal wire how to get it in the vems connector properly?

Title: Re: M50 NV pinout to Vems pinout
Post by: gunni on September 22, 2015, 07:35:40 AM

http://www.vems.hu/files/M50Turbo/VEMS_Non_Vanos_M50_ETM_Guide.pdf

Here is a edited ETM document that shows you how to wire into the VEMS, the Motronic in this document has been replaced by the VEMS and the numbers on the ECU are the VEMS ecu pin numbers

Title: Re: M50 NV pinout to Vems pinout
Post by: maxout on September 22, 2015, 09:05:12 AM

:)

Nice thanx! Regarding the connections it is enough with a regular non insulated crimp tool?

Title: Re: M50 NV pinout to Vems pinout
Post by: maxout on September 22, 2015, 06:42:46 PM

(http://savarturbo.se/~mattias/motor/vems_data/m50/m50-vems.jpg)

is this enough, dont need any relays or fuses extra?

Title: Re: M50 NV pinout to Vems pinout
Post by: gunni on September 22, 2015, 08:37:43 PM

No fuse box has it all, all extra safety is up to you

Title: Re: M50 NV pinout to Vems pinout
Post by: maxout on September 25, 2015, 03:44:30 PM

Does any one have more pics and tips for inspiraton to the coming wiring... 8)

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: maxout on September 22, 2015, 06:35:25 AM