hi guys i have original bosh lsu 4.9 lambda sensor . im calibrating it (164) and then it works fine till i switch engine of. then when im starting engine it works for about 10 sec and dies. any one know what cause this problem ??? have another brand new lambda but for some reason i cant calibrate it. it says increase value but value was set at (255).
any one can help me with that???
triple check your wiring, make sure its warming up and report back.
Its not very common for wideband not to work when in calibration mode
checked wiring many times.and yes it gets very hot cant touch front of the lambda sensor.
how can i add log here?? so you can see how lambda works and later dies
Quote from: wwc_gang on January 05, 2016, 02:03:13 PM
how can i add log here?? so you can see how lambda works and later dies
I have seen similar behaviour with narrowbands before, turned out to be the probe that was broken.
Double check your ground to the wbl again, poor ground to the lambda probes can give all kinds of strange problems.
i done one mistake b4. i connected all wires for lsu 4.2 lambda but was using 4.9 lambda. maybe i can dome some damage to vems ecu itself ???
ok sorted it. installed 27k resistor and now it working :)