Print Page - Secondary Hall. v3.6

Title: Secondary Hall. v3.6
Post by: Kapi306 on May 01, 2016, 02:36:44 PM

Hi!

I want to use sequential fuel injection. I wired the camshaft sensor to EC36 pin 13, but vems do not see the signal..
I have checked with my scop, and signal is there.
I always get LESS SEC TRIG.

Peugeot 306 2.0 16v.

Thanks.

Title: Re: Secondary Hall. v3.6
Post by: MWfire on May 01, 2016, 06:02:30 PM

Is you vems for hall or vr sensor for sec. trigger?

Title: Re: Secondary Hall. v3.6
Post by: Kapi306 on May 01, 2016, 08:04:37 PM

I think its hall.

(http://www.vems.hu/manual/html/images/Testing/v3.6_sec_trigger_1_m.jpg)

there is a 0 ohm in red line.

Title: Re: Secondary Hall. v3.6
Post by: MWfire on May 02, 2016, 01:25:09 PM

Then it's hall.
Also both 2701 resistor are populated?

Title: Re: Secondary Hall. v3.6
Post by: Kapi306 on May 02, 2016, 04:07:37 PM

Here is my board.

(https://www.dropbox.com/s/vfvyw0f8p61xycz/20160502_162927-1.jpg?dl=1)

VEMS Community Forum

Technical => Triggering => Topic started by: Kapi306 on May 01, 2016, 02:36:44 PM