Do you know if the Vems team is presently on holidays?
I got a returned ECU which does not work.
just call them ;) I got my order sent out :) maybe that's wiring problem, not ecu? what's wrong with it?
Quote from: Kamuto on August 12, 2016, 05:15:04 AM
just call them ;) I got my order sent out :) maybe that's wiring problem, not ecu? what's wrong with it?
I bench tested (I am used to bench test the Genboard for years) the ecu with 1.2.35 July14 that I uploaded: at some point the rpm comes slightly wrong and some conflict appears in the config: Channel 6 InjGroup becomes Channel 6 I259 per ex.
Next time I power on I got no communication and I am unable to enter bootloader mode with pin2/3 jumpered as I said to Dave following a Vems report I put.
I may test the Atmega chip with avrdude and for that open the box however I asked Vems for instructions but my request seems to be "silently neglected" for the moment :'(
the problems is 1.2.35 ;) not really good working :)
I have checked the Atmega from ISP. The chip seems ok. The fw 1.2.35 July14 may have been gardening the chip memory?
I may need to burn a fresh bootloader or in any case instruction ::)
I have updated my error reporting with the avrdude log.
What else ? ;D
Quote from: Kamuto on August 13, 2016, 12:30:35 PM
the problems is 1.2.35 ;) not really good working :)
Wrong, 1.2.35 has no known problems (but is still under development), 1.2.34 had one BAD version but as pointed out on: http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FFirmwareChanges It was reverted to the 18apr version.
Best regards, Dave
Indeed I was with the fw 1.2.35 July14 not the July19