Print Page - EDIS CONVERSION

Title: EDIS CONVERSION
Post by: chencho16000 on November 04, 2007, 12:14:23 PM

ITS POSIBLE CONVERT FORD EDIS SYSTEM IN SEQUENCIAL?
ADDING COIL DISTRIBUTOR ?
ADDING 1 COIL 1 CYLINDER?
ANY SUGGESTION?

THANKS.

Title: Re: EDIS CONVERSION
Post by: [email protected] on November 04, 2007, 02:19:01 PM

If you're using VEMS theres no need to use the Ford EDIS module at all. To make things fully sequential you're going to need a cam position sensor.

Title: Re: EDIS CONVERSION
Post by: chencho16000 on November 04, 2007, 08:19:31 PM

it can serve a distributor with hall sensor conect a simple coil?
as it would be the connections scheme?

Thanks.

Title: Re: EDIS CONVERSION
Post by: [email protected] on November 04, 2007, 09:41:23 PM

If the distributor has only one tooth per cam revolution.
Why are you using EDIS?

VEMS Community Forum