Sorry if been covered already.
Is there an step by step from start to finish of fitting a VEMS setup. I like the look of it compared to others around and saw sevensports setup at a Stylus track day. I am building a Stylus with a 3.9ltr rover and not knowing a lot about this would like to do some reading on the vems from what I need to fitting and setting up.
Cheers George
I've done a couple of "complete scratch" installs - ie rewire the whole car type affair. One of them was a heavily modded Rover v8 in my TVR. I tried to document what I did on the VEMS wiki => http://www.vems.hu/wiki/index.php?page=MembersPage%2FDavidBlades
I'm not sure I documented everything because a year later I tore the car apart for a complete rebuild.
Rob's userguide is a good document. It covers just about everything you need to know assuming you have a bit of electrical knowledge.
I believe there's a ready made engine wiring loom available that would even cover a sequential injection/wasted spark v8. All you'd need to do is plug everything together and provide power and ground.
cheers dnb
That should keep me going for a while. Also give me time to move the kit build on and collect parts for the vems setup.
George