VEMS Community Forum

VEMS => Configuration => Topic started by: LGP on April 22, 2019, 02:59:53 PM

Title: VEMS Tune Pressure Gauge and LogView Adjustment
Post by: LGP on April 22, 2019, 02:59:53 PM
Hi, i got a VEMS V3.3 with a 510Kpa MAP sensor in my Audi 5 zyl Turbo.

in the past 3 days im tacking it out to the streets to map the final mapping for 350Kpa setup.
So yesterday ive got to the ClosedLoop PID Boostcontrol settings in charge..

To adjust the PID Settings to a final lvl, i have taken a LOG file of my power runs..
But now in my LOG VIEW on my PC i can't see the full curve of the boost lvl because its cutted off at top of the node panel beacaus the node panel only reaches 300Kpa ??  :o

so any help here or am i doing something completly wrong ?

regards

Title: Re: VEMS Tune Pressure Gauge and LogView Adjustment
Post by: Kamuto on April 22, 2019, 11:42:33 PM
Quote from: LGP on April 22, 2019, 02:59:53 PM
Hi, i got a VEMS V3.3 with a 510Kpa MAP sensor in my Audi 5 zyl Turbo.

in the past 3 days im tacking it out to the streets to map the final mapping for 350Kpa setup.
So yesterday ive got to the ClosedLoop PID Boostcontrol settings in charge..

To adjust the PID Settings to a final lvl, i have taken a LOG file of my power runs..
But now in my LOG VIEW on my PC i can't see the full curve of the boost lvl because its cutted off at top of the node panel beacaus the node panel only reaches 300Kpa ??  :o

so any help here or am i doing something completly wrong ?

regards



you can change maximum value setting
Title: Re: VEMS Tune Pressure Gauge and LogView Adjustment
Post by: gunni on April 23, 2019, 07:36:36 PM
Quote from: LGP on April 22, 2019, 02:59:53 PM
Hi, i got a VEMS V3.3 with a 510Kpa MAP sensor in my Audi 5 zyl Turbo.

in the past 3 days im tacking it out to the streets to map the final mapping for 350Kpa setup.
So yesterday ive got to the ClosedLoop PID Boostcontrol settings in charge..

To adjust the PID Settings to a final lvl, i have taken a LOG file of my power runs..
But now in my LOG VIEW on my PC i can't see the full curve of the boost lvl because its cutted off at top of the node panel beacaus the node panel only reaches 300Kpa ??  :o

so any help here or am i doing something completly wrong ?

regards

https://www.youtube.com/watch?v=6nR7omf2oVI&list=PLF3009C8802794AC1

Have a watch of these videos