I am planning to run a supercharged T5 in a special project and would like peoples thoughts on the best way to go about triggering it.
As far as I can tell at the moment I would need to have a 60-2 primary trigger along
with a secondary cam trigger and run fully sequentially. Is that right??
This is my first management install so I'm feeling in the dark a little.
Cheers
Liam Mc
you can run these enegine only with 60-2 wheel, you need to spark 5 time per crank rotation(wasted spark on one cilynder with cop).
Better way is to run can with cam sync(25 option to sec trigger).
ref trigger table is 0 96 72 48 24
number of teeth 58, next 24
I don't know now what is trigger tooth and deg, but i will start engine tomorow and strobe it.
Thank you, I'd appreciate any guidance you could give.
today i started t5(5cyl) only on 60-2 sensor, i will upload config later.
http://www.vems.hu/wiki/index.php?page=MembersPage%2FDamirMuha%2FPrimaryTriggerOnlyInlineVolvo
awesome, I hope this will help come the time :) much appreciated