VEMS Community Forum
Technical => Triggering => Topic started by: FullGasCZ on December 20, 2021, 09:55:20 pm
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
(http://C:\Users\pc\Downloads\1)
-
https://ibb.co/D5HQbjk
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
(http://C:\Users\pc\Downloads\1)
maybe your ecu is configured with hall trigger hw for secondary trigger?
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
maybe your ecu is configured with hall trigger hw for secondary trigger?
No, ecu is configured correct. Or can i verify it somehow?
photo: https://ibb.co/M7WDYy2
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
maybe your ecu is configured with hall trigger hw for secondary trigger?
No, ecu is configured correct. Or can i verify it somehow?
photo: https://ibb.co/M7WDYy2
on your paper it writes sec trigger hall, and you are using VR sensor for that, so that's your answer..
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
maybe your ecu is configured with hall trigger hw for secondary trigger?
No, ecu is configured correct. Or can i verify it somehow?
photo: https://ibb.co/M7WDYy2
on your paper it writes sec trigger hall, and you are using VR sensor for that, so that's your answer..
Really? i see Sec trig VR, where is the problem?
-
Hi, i have problem with sectric on Mini Mpi, it is stock VR sensor and ecu dont accept this signal. It should be that voltage on the peak is too low? Or shape of curve is incorrect? The sensor is in the groove in the lobe of camshaft.
Thank You for answer
maybe your ecu is configured with hall trigger hw for secondary trigger?
No, ecu is configured correct. Or can i verify it somehow?
photo: https://ibb.co/M7WDYy2
on your paper it writes sec trigger hall, and you are using VR sensor for that, so that's your answer..
Really? i see Sec trig VR, where is the problem?
you are right.. my bad