VEMS Community Forum

VEMS => Configuration => Topic started by: Seight-v8 on May 23, 2011, 07:11:00 pm

Title: ve table
Post by: Seight-v8 on May 23, 2011, 07:11:00 pm

hello all,

If i wanted to change the full VE table by -20% is there a quick way of doing it or do i have to change each cell seperately.

I've fitted a new plenum chamber and looks like i now need 20% less fuel in the table.

I've changed all the cells around idle and its much better.

Tried the new autotune, but the table is just too far away to use this feature.

cheers

scott

Title: Re: ve table
Post by: Erikk on May 23, 2011, 07:30:40 pm

Tuning -> RPM/MAP Fuel VE  (the 2D table)
Select the cells you want to change and rightclick the table and choose Multiply selected cells.
Write 0.8 and you´re set.

Title: Re: ve table
Post by: Seight-v8 on May 23, 2011, 07:38:27 pm

erikk,

cheers as thats done the trick....ready for next run now.

thats much quicker than doing it the hard way....by working out each cell.

scott