VEMS Community Forum
Technical => Triggering => Topic started by: kkh on April 03, 2008, 10:02:22 pm
-
Hi
I got a crankshaft sensor (6PU 009 146-151) with 3 wires that was bourght fore a early C20XE, dos any one know if this is a Hall-sensor?
Thanks
Hans
-
It is vr sensor. Third wire is shild. Red wire is -, black wire is +.
-
It is vr sensor. Third wire is shild. Red wire is -, black wire is +.
Thanks alot, but I don't have the original wire-harness so I can't see which one is red and black.
Any ide which one is pin-1,2,3?
-
take measurements of the resistances across the pins. Pin3 will be the sheild so it will give no reading across the other pins.
-
take measurements of the resistances across the pins. Pin3 will be the sheild so it will give no reading across the other pins.
Yes I see but dosent it mather which one I use as + and - (pin 1-2)?
-
It's matter. If you connect opposite you couldn't read rpm.
1pin +
2pin -
3pin shild
-
It's matter. If you connect opposite you couldn't read rpm.
1pin +
2pin -
3pin shild
Thanks alot.
I'll post my project when I get the 36-1 and waste-spark installed.