VEMS Community Forum

Technical => Ignition => Topic started by: lost on February 21, 2019, 06:18:47 pm

Title: Using stock ignition modules.
Post by: lost on February 21, 2019, 06:18:47 pm

Can VEMS fire this bosch ignition module with logic level output without IGBT?

Are some in-line resistors required.

Specs in PDF
http://www.bosch-motorsport.de/content/downloads/Products/resources/2778342155/en/pdf/Ignition_Module_IM_3.2_Datasheet_51_en_2778309387.pdf (http://www.bosch-motorsport.de/content/downloads/Products/resources/2778342155/en/pdf/Ignition_Module_IM_3.2_Datasheet_51_en_2778309387.pdf)

Or maybe better option is to fire coils with IGBT directly? I'm affraid of "noise" and heat problems with IGBT's in box.

Title: Re: Using stock ignition modules.
Post by: jrussell on February 21, 2019, 06:25:57 pm

That should work. Looks like the same module as the AAN audi uses. I wouldn't worry about an IGBT inside the case though. Thousands of people are using it that way without issues. But up to you. Either way should work fine.

Title: Re: Using stock ignition modules.
Post by: lost on March 09, 2019, 02:52:51 pm

Thanks,

if i use IGBT inside vems case without cooling in sequential mode, would it work or would ther overheat?
I have stock passive 0221504456 BOSCH IGNITION COILs



https://www.ebay.co.uk/itm/0221504456-BOSCH-IGNITION-COIL-IGNITION-COIL-PACK-BRAND-NEW-GENUINE-PART/182283264186?_trkparms=aid%3D555018%26algo%3DPL.SIM%26ao%3D1%26asc%3D20140122125356%26meid%3Dac6f432885fb4c168a0d1c5943ec5845%26pid%3D100005%26rk%3D1%26rkt%3D12%26sd%3D253228608941%26itm%3D182283264186&_trksid=p2047675.c100005.m1851 (https://www.ebay.co.uk/itm/0221504456-BOSCH-IGNITION-COIL-IGNITION-COIL-PACK-BRAND-NEW-GENUINE-PART/182283264186?_trkparms=aid%3D555018%26algo%3DPL.SIM%26ao%3D1%26asc%3D20140122125356%26meid%3Dac6f432885fb4c168a0d1c5943ec5845%26pid%3D100005%26rk%3D1%26rkt%3D12%26sd%3D253228608941%26itm%3D182283264186&_trksid=p2047675.c100005.m1851)