VEMS Community Forum

VEMS => Calibration & Mapping => Topic started by: Kamaro on October 20, 2019, 08:10:26 pm

Title: First VEMS install, stuck in safety mode!
Post by: Kamaro on October 20, 2019, 08:10:26 pm
I just finished installing all the VEMS hardware into my 1986 3.2 Porsche Carrera, all went well until I reached the point where I went to calibrate the WB sensor, I heard the #4 injector was clicking for a while and then the ECU went into safety mode!, I tried to switch it off/on with no success, how can I get myself out of that???
Title: Re: First VEMS install, stuck in safety mode!
Post by: MWfire on October 21, 2019, 10:46:36 am
you need to upload good config.