VEMS Community Forum
Technical => Triggering => Topic started by: derill3237 on May 21, 2020, 10:25:35 am
-
Help I can not start a Subaru with a trigger of 6 7 ...
Primary trigger error ..
Software 1.2.11 ...
-
Help I can not start a Subaru with a trigger of 6 7 ...
Primary trigger error ..
Software 1.2.11 ...
maybe wrong polarity?
-
Help I can not start a Subaru with a trigger of 6 7 ...
Primary trigger error ..
Software 1.2.11 ...
maybe wrong polarity?
tried to change, nothing changed
-
Help I can not start a Subaru with a trigger of 6 7 ...
Primary trigger error ..
Software 1.2.11 ...
maybe wrong polarity?
tried to change, nothing changed
Here is a link to triggerlog: http://wdfiles.ru/6xld
-
Trigger log looks good.
http://www.vems.hu/wiki/index.php?page=InputTrigger%2FSubaruTrigger
Upload your config.
-
Trigger log looks good.
http://www.vems.hu/wiki/index.php?page=InputTrigger%2FSubaruTrigger
Upload your config.
Thanks .. I started the car ..
The problem was the following ...
Next trigger Tooth had a value: 1
When I chose Subaru 6 7 from the list ...
Changed this value to 3 and received a working signal ... but .... Now Config sanity check weighs an error ... while everything works fine ...
If you help me figure out what’s going to be, I will be very grateful ..