Author Topic: 60-2 no trigger signal either with hall or VR  (Read 1825 times)

Offline tschoenacher

  • New Users
  • *
  • Posts: 1
  • BHP: 0
60-2 no trigger signal either with hall or VR
« on: April 30, 2021, 04:23:00 pm »
Hello,

i have a V3 (board version 3.8), directly ordered from vems.hu
Primary trigger=VR / secondary=hall

I have an alfa 4cyl twinspark engine, stock 60-2 wheel on crank, running on wasted spark.

Wiring checked about 10 times, every in- and output is working, but i just canĀ“t get any VR signal in triggerlog with the stock sensor.

Changed to hall sensor, use secondary as primary, but no usable hall signal in triggerlog. 20s cranking gives just about 1s of signal.

Could anyone give me a hint where to find my mistake?
Do you need any files from me for helping?

Thank you very much,
Thomas

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: 60-2 no trigger signal either with hall or VR
« Reply #1 on: April 30, 2021, 08:22:34 pm »
probably p259 chip dead :) happens with wiring mistakes
Vems installer in Lithuania
[email protected]