Author Topic: Knock sampling Settings (Knock Chan) for 2 Knock Sensors?  (Read 20807 times)

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Knock sampling Settings (Knock Chan) for 2 Knock Sensors?
« Reply #15 on: September 27, 2015, 01:36:10 pm »
just use one sensor and that's all :)
Vems installer in Lithuania
[email protected]

Offline black

  • Jr. Member
  • **
  • Posts: 76
  • BHP: 0
Re: Knock sampling Settings (Knock Chan) for 2 Knock Sensors?
« Reply #16 on: September 27, 2015, 02:10:01 pm »
just use one sensor and that's all :)

The first or the second?  :D

Offline VEMS

  • Administrator
  • Sr. Member
  • *****
  • Posts: 487
  • BHP: 22
Re: Knock sampling Settings (Knock Chan) for 2 Knock Sensors?
« Reply #17 on: September 28, 2015, 08:30:06 am »
Hello Black,

Mh... I don't see only a shift...  cylinder numbers in knock channels do not match to the numbers in the report numbers. So the knock sensor my not match to the right cylinder. But to get that clear, I will simply disconnect one knock sensor an see what cylinders are effected. Window length will be corrected.
Firing order: 12453 when the first cylinder has (cyl#1) fired, the order of cylinders to fire next becomes (and cyl#1 becomes the last in line): 24531, its the same order just one cylinder sequence further. Lets make it even easier just forget about the numbers in front of knock sensor channels and gain settings (they are imaginary not cylinder numbers) the numbers in reporting in above knock columns gauge are cylinder numbers.

Best regards, Dave

Offline black

  • Jr. Member
  • **
  • Posts: 76
  • BHP: 0
Re: Knock sampling Settings (Knock Chan) for 2 Knock Sensors?
« Reply #18 on: October 06, 2015, 06:29:15 pm »
short Feedback... after disconnecting one knock sensor I have to say sequence and cylinder assignment is wrong...  I will try to discover the right sequence soon..