Author Topic: VR6 trigger w/ multi tooth (MK4) cam/gear?  (Read 3668 times)

Offline NOTORIOUS VR

  • Full Member
  • ***
  • Posts: 213
  • BHP: 5
VR6 trigger w/ multi tooth (MK4) cam/gear?
« on: November 20, 2015, 04:47:20 pm »
Wondering if someone would be able to help me out with setting up the sec. trigger correctly.

12V VR6 w/ MK4 cams... so this means not the simple 1 window cam.

it has this:



Attached is a trigger log I took (although I do believe that there was an issue with the primary trigger - car ran but was kinda weird and didn't want to start right off the bat without a few pops - this has been corrected now by the installer/shop)

https://dl.dropboxusercontent.com/u/56237915/v3.3_u011107-2015-11-12-19.48.23.triggerlog

Thanks!


Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: VR6 trigger w/ multi tooth (MK4) cam/gear?
« Reply #1 on: November 20, 2015, 09:47:07 pm »
set secondary trigger to rising edge and make trigger log, then it should be different, and you will be able to use sec ignore options :)
Vems installer in Lithuania
[email protected]