Author Topic: VR to HALL  (Read 4416 times)

Offline beny1989

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 0
VR to HALL
« on: November 28, 2016, 01:45:18 pm »
Hello
I have a problem with plugging the converter VR to HALL:
https://shop.vems.hu/catalog/hall-p-162.html

How do I connect to my VR signal is converted into the Hall signal as required by the ECU. It is the trigger wheel signal.
Sorry for bad English

Offline Mads Lund

  • Jr. Member
  • **
  • Posts: 61
  • BHP: 4
    • VEMS member
Re: VR to HALL
« Reply #1 on: November 28, 2016, 09:34:05 pm »
Hi

Do your Vems have primary trigges as Hall ? in case, then I think it's better to modify your board to run VR, and connect the sensor directly to the ECU.

Guide to check and perhaps modify is here http://www.vems.hu/wiki/?page=GenBoard%2FManual%2FInputTriggerHardWare

Please post some similar pictures from your own board, and we can verify you hardware setup.

Br Mads

Offline beny1989

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 0
Re: VR to HALL
« Reply #2 on: November 29, 2016, 10:10:10 am »
I have an old Megasquirt which only supports Hall.

Offline Mads Lund

  • Jr. Member
  • **
  • Posts: 61
  • BHP: 4
    • VEMS member
Re: VR to HALL
« Reply #3 on: November 29, 2016, 03:23:56 pm »
It can be, that you need a pull-up resistor between +5v and the hall input.

Offline beny1989

  • Jr. Member
  • **
  • Posts: 3
  • BHP: 0
Re: VR to HALL
« Reply #4 on: January 05, 2017, 05:16:22 pm »
Hi engine now running with this converter but rev up just to 1500 rpm, wiht 1kohm resistor on Vr sensor wire it rev up to 3500 but if I add on more resistor engine dies. Can you help me with those resistors? thanx