Author Topic: Stm32f105 ARM based dauther board for vems for canbus  (Read 1611 times)

Offline mr_g

  • Full Member
  • ***
  • Posts: 198
  • BHP: 9
    • View Profile
Re: Stm32f105 ARM based dauther board for vems for canbus
« Reply #45 on: September 18, 2017, 01:05:27 pm »
This is something similar. But mine is better, smaller (40x12mm) and cheaper... :D
https://www.tindie.com/products/protofusion/canable-usb-to-can-bus-adapter/

This is sent to PCB manufacturer. I have a customer request on a project and this is required... It has free UART on bottom.



Offline Kamuto

  • Hero Member
  • *****
  • Posts: 667
  • BHP: 16
    • View Profile
Re: Stm32f105 ARM based dauther board for vems for canbus
« Reply #46 on: September 25, 2017, 09:16:14 pm »
any news on dbw?
Vems installer in Lithuania
valdas.sunokas@gmail.com

Offline mr_g

  • Full Member
  • ***
  • Posts: 198
  • BHP: 9
    • View Profile
Re: Stm32f105 ARM based dauther board for vems for canbus
« Reply #47 on: October 09, 2017, 11:48:31 am »
Yes, I got everything from china. I'm still waiting for some headers for daughter board...

Outputs board.




VEMS H bridge





soldered on VEMS:



VEMS daughter board (not soldered completely)





Programming connector



I'm working on something for e-motorcycle so I'dont have much spare time (about 15x15cm, 100 pin ARM STM32F105VCT6, 2xCANBUS, 50V power supply, 13V 20A output, 10x power outputs, etc)...




Offline Kamuto

  • Hero Member
  • *****
  • Posts: 667
  • BHP: 16
    • View Profile
Re: Stm32f105 ARM based dauther board for vems for canbus
« Reply #50 on: October 19, 2017, 06:15:38 pm »
so, how's dbw? got it working?
Vems installer in Lithuania
valdas.sunokas@gmail.com