« previous next »
Pages: [1]

Author Topic: Vems data to dash2pro problem  (Read 6725 times)

Offline martin.ring

  • New Users
  • *
  • Posts: 1
  • BHP: 0
Vems data to dash2pro problem
« on: February 21, 2019, 09:26:13 am »
Hi i got a dash2pro i like to connector to my vems ecu, so i get the info there.


But i dont get any data?
My vems and dash2pro is not installed, its on a table, but belive they still can?

Maybe someone have this setup and can send me a file with vems setup so i know that is setup right?

Reguards
Martin
Logged

Offline jrussell

  • VEMS USA
  • Administrator
  • Full Member
  • *****
  • Posts: 221
  • BHP: 15
    • VEMS USA
Re: Vems data to dash2pro problem
« Reply #1 on: February 21, 2019, 05:29:25 pm »
Make sure AIM is enabled on the ECU and use AIM mode on the dash?
Logged
VEMS USA - Located in beautiful Burlington, Vermont
1988 RX7 Turbo

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Vems data to dash2pro problem
« Reply #2 on: February 24, 2019, 12:19:51 am »
Quote from: martin.ring on February 21, 2019, 09:26:13 am
Hi i got a dash2pro i like to connector to my vems ecu, so i get the info there.


But i dont get any data?
My vems and dash2pro is not installed, its on a table, but belive they still can?

Maybe someone have this setup and can send me a file with vems setup so i know that is setup right?

Reguards
Martin
check racetechnology page, it has all the instructions for that :)
Logged
Vems installer in Lithuania
[email protected]
Pages: [1]
« previous next »