Author Topic: Does this triggerlog look right? 1.8T AEB  (Read 4713 times)

Offline bonden

  • Jr. Member
  • **
  • Posts: 6
  • BHP: 0
Does this triggerlog look right? 1.8T AEB
« on: November 30, 2017, 12:04:09 pm »
Hi folks. I have setup my primary VR and secondary HALL sensor, and i have the following triggerlog. I believe the signals are ok, but still, the ignition outputs seem of.
If you could point me in the right direction for getting the correct spark timing, i would be very gratefull!  :)
http://i954.photobucket.com/albums/ae26/christiancdk/Primary%20trigger_zps0p8yfkbf.png~original
This is my trigger settings, TDC after trigger is at 78 now.

Ignitions settings as follows:
« Last Edit: November 30, 2017, 12:06:09 pm by bonden »

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Does this triggerlog look right? 1.8T AEB
« Reply #1 on: December 03, 2017, 03:13:34 pm »
What do you mean by seems of?

Can you produce a triggerlog and a vemslog of the engine cranking or running?

Offline bonden

  • Jr. Member
  • **
  • Posts: 6
  • BHP: 0
Re: Does this triggerlog look right? 1.8T AEB
« Reply #2 on: December 05, 2017, 07:03:05 am »
Hi gunni

I have the following triggerlog:

When i say it seems off, i mean that there are only one ignition/spark per 360 rotation, maybe even less. There should be 2 (im not running wasted spark) I have changed the TDC after trigger to 78 since this log was made, i might try 54 degrees (13-4 teeth, 6 degrees apart).
The engine is only cranking, not starting on this log.

The rest of the setup:



« Last Edit: December 05, 2017, 07:12:12 am by bonden »

Offline bonden

  • Jr. Member
  • **
  • Posts: 6
  • BHP: 0
Re: Does this triggerlog look right? 1.8T AEB
« Reply #3 on: December 11, 2017, 10:42:17 am »
I could not get this sequiental firing to work, so i'm running without cam-sync now, and just using 2 stepper outputs, thereby running wasted spark setup, and it works like a charm now.