Author Topic: Enable AIM mode  (Read 2954 times)

Offline fphil

  • Sr. Member
  • ****
  • Posts: 398
  • BHP: 6
Enable AIM mode
« on: February 09, 2018, 09:32:19 pm »

How do you enable this option "AIM mode" from "Preferences/cCommunications settings".
I  never get the option "yes" to select, always "no"
I have set  "AIM Stream setting/AIM" Enable and restarted everything before.

The documentationfrom the button next to it says:
"If this option is enabled, AIM communication will be used, if incoming AIM is detected"

I wanted to check the AIM stream on the first UART using this mode...

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Enable AIM mode
« Reply #1 on: February 10, 2018, 11:17:19 am »

How do you enable this option "AIM mode" from "Preferences/cCommunications settings".
I  never get the option "yes" to select, always "no"
I have set  "AIM Stream setting/AIM" Enable and restarted everything before.

The documentationfrom the button next to it says:
"If this option is enabled, AIM communication will be used, if incoming AIM is detected"

I wanted to check the AIM stream on the first UART using this mode...

aim is enabled in software, not vemstune preferences
Vems installer in Lithuania
[email protected]

Offline fphil

  • Sr. Member
  • ****
  • Posts: 398
  • BHP: 6
Re: Enable AIM mode
« Reply #2 on: February 10, 2018, 03:47:59 pm »
Right, this is why I have set  "AIM Stream setting/AIM" on "Enable" from VT and have restarted V3 (and VT).

So what is this VT option "AIM mode" from "Preferences/Communications settings" for? and how do you enable it?
I understand, for the less, that this  is to run VT in a certain communication mode related to AIM. Do you know more? Is is documented somewhere?