Author Topic: Fault in documentation?  (Read 7206 times)

Offline Rak

  • Jr. Member
  • **
  • Posts: 24
  • BHP: 0
Fault in documentation?
« on: April 14, 2018, 11:08:17 am »
i been looking analog channels from board.

Noticed that in diagram MCP3208CISL channels are numbered 8-3, ch8 beeing up right corner.

http://www.vems.hu/files/genboardv3/v3.3/v33_sch.pdf

But, when i am looking my board, ec18 pin 12, wich is ch7 in pin out, connects that corner spot?

Am i missing something?

Edit: And bottom side on my board says v3.4?
« Last Edit: April 14, 2018, 11:37:29 am by Rak »
V3.3 1652
FW 1.2.38

Offline Rak

  • Jr. Member
  • **
  • Posts: 24
  • BHP: 0
Re: Fault in documentation?
« Reply #1 on: April 14, 2018, 12:44:17 pm »
I was missing that channel numbering in vemstune starts from 0  :-[

I think it would clarify things if the numbering was the same.
V3.3 1652
FW 1.2.38