At my wits end with this crank trigger - the saga continues!!

[Bat]

Hi,
Beware the ALS that enables itself when you change settings in offline mode!
Just Go into anti lag settings and change the channel to disabled
Cheers,
Gavin

[[email protected]]

Good point - if the DisableALS.txt configlet is used when generating the config then the ALS will have no effect on the system as I've set all the values to being impossible to reach (e.g. Min RPM = 25500 Max RPM = 0)  but its best to have the ALS input switched to disabled.

[Denmark]

Bat,

That moving pic you have in the bottum of your text is just plain annoying

[Valver.]

Tried changing the spark channels in MT to 10 and 20/Pinouts 33 & 34 to which the coils are wired and have lost spark altogether 

The H[2] is 10 20 10 20 10 20 10 20 which should be correct aswell. I haven't even got to checking the fuel delivery yet...

[[email protected]]

What was it before?

[Bat]

Hi,
It may be that the ignition drivers in the ECU aren't fitted to those two pins. As Rob says what were the settings before hand?
Cheers,
Gavin

[[email protected]]

chances are it should be 34 and 36 -
h[2] = 20 30 20 30 20 30 20 30