« previous next »
Pages: [1]

Author Topic: Spark CUT  (Read 7759 times)

Offline Matus

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 0
Spark CUT
« on: May 04, 2018, 11:58:17 am »
HI,

I am experiencing issue similar like misfire but I found that it is "on purpose" ECU by some reason is doing 100% Spark  Cut for unknown reason, in random RPM.
I am able to simulate conditions like you have lifted car spinning engine on 5 gear and doing load by brake. It would be considered as low-medium load.

Logged

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Spark CUT
« Reply #1 on: May 04, 2018, 02:49:29 pm »
Quote from: Matus on May 04, 2018, 11:58:17 am
HI,

I am experiencing issue similar like misfire but I found that it is "on purpose" ECU by some reason is doing 100% Spark  Cut for unknown reason, in random RPM.
I am able to simulate conditions like you have lifted car spinning engine on 5 gear and doing load by brake. It would be considered as low-medium load.


do you think, would it be easier to understand what's causing it if you uploaded some log? :D
Logged
Vems installer in Lithuania
[email protected]

Offline Matus

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 0
Re: Spark CUT
« Reply #2 on: May 04, 2018, 02:58:42 pm »
Logged

Offline Matus

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 0
Re: Spark CUT
« Reply #3 on: May 07, 2018, 01:45:43 pm »
Any  ideas guys ?

For example I didn't found " spark cut" except REV limiter and Launch control and didn't seen that also within that "calculation" view...
Are reasons/functions for it documented somewhere ?
Logged

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: Spark CUT
« Reply #4 on: May 07, 2018, 06:41:39 pm »
Quote from: Matus on May 07, 2018, 01:45:43 pm
Any  ideas guys ?

For example I didn't found " spark cut" except REV limiter and Launch control and didn't seen that also within that "calculation" view...
Are reasons/functions for it documented somewhere ?

Anti lag(ALS) is on.
Logged

Offline Matus

  • Jr. Member
  • **
  • Posts: 72
  • BHP: 0
Re: Spark CUT
« Reply #5 on: May 15, 2018, 04:45:47 pm »
Cause has been found.

Anytrim    Redline RPM Trim for Lambda target 60% TPS  and Lambda target 90% TPS was used. In meaning of engine protection. However it was doing these cuts arround 15% of the TPS so it is not configured as I think.
 
Logged

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Spark CUT
« Reply #6 on: May 16, 2018, 01:06:19 am »
Quote from: Matus on May 15, 2018, 04:45:47 pm
Cause has been found.

Anytrim    Redline RPM Trim for Lambda target 60% TPS  and Lambda target 90% TPS was used. In meaning of engine protection. However it was doing these cuts arround 15% of the TPS so it is not configured as I think.
 
read help file, 60 means not over 60% but bit different :) I would like it to be working different too :)
Logged
Vems installer in Lithuania
[email protected]
Pages: [1]
« previous next »