Author Topic: Audi RS2  (Read 217296 times)

Offline AVP

  • Hero Member
  • *****
  • Posts: 743
  • BHP: 11
Re: Audi RS2
« Reply #420 on: December 14, 2011, 07:43:23 am »
Update.

after a few runs yesterday on the setting of the WI that i have with the snow perfomance controller, i saw that mixture was getting closer to 0.79 and 0.78 ever so slightly.

IATs and EGTs where also slightly lower.

SO after i fit the safe injection controller and wire that to the config switch so that it switches configs as safety in case of low flow, i will adjust the fuelling a bit and give some more timing (little by little) to see if i get any gains.


Offline DevInAz

  • Full Member
  • ***
  • Posts: 181
  • BHP: 7
Re: Audi RS2
« Reply #421 on: December 14, 2011, 10:22:59 pm »
What is this virtual dyno software you are using? maybe I didn't look back in your thread far enough.

Offline AVP

  • Hero Member
  • *****
  • Posts: 743
  • BHP: 11
Re: Audi RS2
« Reply #422 on: December 15, 2011, 07:03:34 am »
its a little excel that when you input time vs rpm on 3d or 4th gear and also input the gear ratio/weight/frontal area of car/tyres it can generate a power/torque figure for each run you do, so long as you do a proper full throttle 3d or 4th gear pull on a level plain road.