Author Topic: '83 BMW 628csi S38B38 project  (Read 187 times)

Offline Timmo6

  • Jr. Member
  • **
  • Posts: 40
  • BHP: 2
'83 BMW 628csi S38B38 project
« on: July 04, 2019, 04:43:28 pm »
Hi all,
Back from a while I am going to collect my vems v3.3 board again and start a new project for my full restoration 628csi project.
The car is at the bodyshop for a full restauration so I have the time to put things together regarding vems.
As I used the board for a 4cyl bmw518i with Hall pick up I need to resolder the board and adapt it for a 6cyl S38B38 with COP and VR pickup.
I bought a new VEMS wiringloom to Ensure a clean setup.
I have a few questions which I will post in the proper topic.
grtz
Tim

Offline msh

  • Jr. Member
  • **
  • Posts: 22
  • BHP: 0
Re: '83 BMW 628csi S38B38 project
« Reply #1 on: September 02, 2019, 08:05:09 am »
For a clean setup you need some BMW engine loom from related engine to cut up for connectors, not VEMS loom - VEMS loom has been engineered for racecars, where bunch of additional relays can be useful and too long wires tied with cable straps doesn't matter - for a classic BMW properly made custom loom would be much nicer :)