Author Topic: First VEMS install, stuck in safety mode!  (Read 7155 times)

Offline Kamaro

  • New Users
  • *
  • Posts: 1
  • BHP: 0
First VEMS install, stuck in safety mode!
« on: October 20, 2019, 08:10:26 pm »
I just finished installing all the VEMS hardware into my 1986 3.2 Porsche Carrera, all went well until I reached the point where I went to calibrate the WB sensor, I heard the #4 injector was clicking for a while and then the ECU went into safety mode!, I tried to switch it off/on with no success, how can I get myself out of that???

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: First VEMS install, stuck in safety mode!
« Reply #1 on: October 21, 2019, 10:46:36 am »
you need to upload good config.