Technical > Wideband & EGT Gauge

Wideband & EGT Default Configuration

(1/3) > >>

[email protected]:
Published for reference only - you do not need to adjust anything.

Once again the Pump PW Zero and Nerst DC target are specific to your gauge and should not be touched

billman:
Hi i have seen that many Audi I5 files use these settings for the WB. What is the way to go?





These are the data provided from VEMS. Wha tsettings should i use?

Serial_nr= 1441
pump-= 4.14V
wbo2_pump_pw_zero=0x67
wbo2_nernstdc_target=0x85
pump+= -3.3mV/200 Ohm
AREF=4.9V
(C103=1nF, no D100)

Regards,

Vasilis

[email protected]:
Ah... The problem is that I put the Wideband and EGT settings in the VEMS->Configuration and it should have been in the Wide band's only section.
This is what you need:
http://www.vems.co.uk/forum/index.php?topic=55.0

billman:
This means that my settings should look like this?



[email protected]:
On a VEMS V3 ECU or a Wideband and EGT guage?

Navigation

[0] Message Index

[#] Next page

Go to full version