Author Topic: Auditrigger-engine not starting  (Read 3116 times)

Offline Reini1977

  • Jr. Member
  • **
  • Posts: 14
  • BHP: 0
Auditrigger-engine not starting
« on: January 29, 2020, 08:46:14 pm »
hi all

built a new I5 20V motor, FW 1.2.38

i have rpm signal, i have fuel injection, i have spark, but engine behave as following

when i set cam sync wheel to TDC (wrong setup) , engine starts, but a bit on the gas, and i get trigger errors

when i set cam sync so, that the hall sensor is in the window exactly when crankhome pin is on the VR sensor (setup correct like factory), i can do what i want, the engine doenst start

tried everything, richening up, leaning out, use different offset angles, nothing

it sounds like from time to time i have a hissing noise in the exhaust, but nothing more

can you give me a direction?

regards



Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: Auditrigger-engine not starting
« Reply #1 on: January 29, 2020, 10:16:58 pm »
Upload a config and trigger log.
Did you change polarity of tdc home sensor?

Offline Reini1977

  • Jr. Member
  • **
  • Posts: 14
  • BHP: 0
Re: Auditrigger-engine not starting
« Reply #2 on: January 30, 2020, 04:49:48 am »
thank you

will do so, when i have access to my Notebook again..tomorrow

yes, swapped the polarity, can verify with scope if necessary...

also, i have a nice trigger signal and rpm

plugs are firing, injectors are working

is it possible that i have to shift the ignition order?

regards