Author Topic: closed loop shift cut? 1.2.43  (Read 769 times)

Offline mk123gti

  • Jr. Member
  • **
  • Posts: 5
  • BHP: 0
closed loop shift cut? 1.2.43
« on: September 04, 2020, 09:02:31 am »
Hello,  I just uploaded the new firmware for the closed loop shift cut function. I have a sequential gearbox with a strain gauge and drumsensor all wired up to the ECU I cannot seem to get the shift cut to active in closed loop mode.  It seems to work fine in normal mode. the drum sensor works fine for gear location. Is there anyone on here that has set up the closed loop shift cut feature in the new FW?  I see it says experimental in the release, however I really need a closed loop function to work for my car, the timed cut is really hard on my gearbox, I have already snapped an input shaft. Kotouc has recommended that I switched to a closed loop strategy to save parts.  Geartronix makes an add on box but I would like to use the built in vems feature If I can.
Any help or advice is much appreciated.