VR6 Turbo trigger and secondary trigger settings does not match

[GUTIS]

hello , i have done project corrado 2.8vr6 Turbo with vems 3.3 firmware 1.1.9.8,primary trigger(60-2) vr sensor , secondary hall,trigger  With one window,cant start the engine,in the beginning was problem with  too many secondary triggers ,after i use alien advice its came good,but now secondary trigger in the trigger log is too far from primary trigger what can i do?Both triggers  set out originaly place,Can i programly do or i need mechanical change position secondary trigger?Trigger 60-2
Also what is the right order for the ignition with 6 coils and injectors i am using sequent injection
0 -?
1-?
2-?
3-?
4-?
5-?
Maybe  someone  have vr6 with obd2 ,6 coils, all the settings of vems it will be easier me to program for me,Thanks

[GintsK]

You must use Camsync not Alien advance.

From your picture seems cam sensor gives two signals per 720deg. In this case you can adjust Ignore sec trig pulses above. It is tooth count after the missing. 10 should work OK.

Gints

[GUTIS]

now i,m use camsync(tonight will try your,s way) but wat about order ignition(coils) and injectors?could someone wright?
0-?
1-?
2-?
3-?
4-?
5-?

[GintsK]

Then post your ref tooth table first!

[GUTIS]

WHAT IS ref tooth table?

[GintsK]

ref=reference

[GUTIS]

i have uploaded new version of firmvare 1.2.2 and config 1.2.0 after that we changed Ignore sec trig pulses above 10,and engine does not start,now triggers ok,now we got

what can i do ?


Do this settings good?

[GintsK]

One more problem - you have wrong polarity for VR sensor. Note the one uneven signal in missing gap!

With your ref tooth table ignition and injection outputs should look like this:

0 Coil 1-6 injector1
1 Coil 3-4 injector4
2 Coil 2-5 injector2
3 Coil 1-6 injector6
4 Coil 3-4 injector3
5 Coil 2-5 injector5

Or shifted (injectors) by 3 places up if cam signal occurs in another revolution before power stroke of cyl6. You can check it by disabling coil and injector from row with same number. At this test only one cylinder should misfiring, not two. 

[GUTIS]

how to change VR polarity,thanks try to continue

[GintsK]

how to change VR polarity,thanks try to continue

By interchanging two sensor wires.

[GUTIS]

we changed polarity and nothing,so we mechanical changed secodary trigger hall sensor position and now it,s ok, but in the trigger log doesnt exist spark event,what can i do?on the alien advice it works perfect,but then i choose cam sync,where is no spark?

[GintsK]

Can you post your current .vemscfg and .trigerlog files. Otherwise it is just guess.

[GUTIS]

[GUTIS]

can you give me your email because i dont have online ftp  storage,and i sent you config file

[GintsK]

You can use Help->Vems sharining center  in Vemstune. And post link here.