bmw 60-2 vr primary, secondary hall and 1.1.43alpha

[Tobias]

Hello,

Im installing vems on a bmw 6cyl. I am using 60-2 vr crank sensor, tooth 0(first tooth after gap) is 84 degrees BTDC and im using tooth 0 for cyl 1 trigger... Hall sensor on the cam that will trigg(rising edge) about 20 degrees ATDC on cyl 2. Firing order is 1-5-3-6-2-4.

Does this seem right?

what values should i use for  " Cam sync, engine phase at next primary trigger" - Falling edge and rising edge?
The falling edge of the cam trigger should not overlap cyl 4 ignition window.

Is the 1.1.43alpha good to use for my setup?

[[email protected]]

First off try using the setup without cam trigger as it makes things a little complicated.
I would start with 1.0.78 to start off with.