VEMS Community Forum

Technical => Solenoids => Topic started by: rossi46numberone on February 09, 2011, 04:22:59 AM

Title: PWM output freq. issue....
Post by: rossi46numberone on February 09, 2011, 04:22:59 AM
Hi,
I've tried to use the PWM output to drive my Pololu/thorttle body systems,but the problem is that the frequency output is too low,250 Hz is not enough :'(.
I need around 10 Khz,is there a solution to reach this frequency needed?
Title: Re: PWM output freq. issue....
Post by: Denmark on February 09, 2011, 05:08:11 PM
the newagde subaru is also 1khz,


/Skassa