Author Topic: v3.8 board sec trigger conversion hall>vr type  (Read 9154 times)

Offline Sam8888

  • Jr. Member
  • **
  • Posts: 63
  • BHP: 0
Re: v3.8 board sec trigger conversion hall>vr type
« Reply #15 on: November 01, 2016, 01:51:22 pm »
On the link it says use Hall on both.

"Leaving the 360 impulse disk - implementation works well (slightly above 10000 RPM on bench)

the 4 (or 6) window pulse connected to primary-trigger HALL input
the 360 pulse signal connected to sectrig HALL input (without any hardware divider !)
lower filtering capacitor must be used of course, so mention "sectrig=HALL,Nissan360pulse" in the order comment
See "Nissan special settings" in [VemsTune Help] on how to measure the length of the longest primary trigger window (if you don't know, or want to verify)"

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: v3.8 board sec trigger conversion hall>vr type
« Reply #16 on: November 01, 2016, 05:23:22 pm »
On the link it says use Hall on both.

"Leaving the 360 impulse disk - implementation works well (slightly above 10000 RPM on bench)

the 4 (or 6) window pulse connected to primary-trigger HALL input
the 360 pulse signal connected to sectrig HALL input (without any hardware divider !)
lower filtering capacitor must be used of course, so mention "sectrig=HALL,Nissan360pulse" in the order comment
See "Nissan special settings" in [VemsTune Help] on how to measure the length of the longest primary trigger window (if you don't know, or want to verify)"

yes hall both :)
Vems installer in Lithuania
[email protected]

Offline sandokan

  • Jr. Member
  • **
  • Posts: 14
  • BHP: 0
Re: v3.8 board sec trigger conversion hall>vr type
« Reply #17 on: November 05, 2016, 05:45:58 pm »
Thanks problem solved car works